Difference between revisions of "SUNScholar/Upgrading/Hardware/Add a New Disk"

From Libopedia
Jump to navigation Jump to search
Line 35: Line 35:
  
 
Type the following to create an '''ext4''' file system on the disk;
 
Type the following to create an '''ext4''' file system on the disk;
−
  mkfs.ext4 /dev/sdb1
+
  sudo mkfs.ext4 /dev/sdb1
  
 
==Step 4==
 
==Step 4==

Revision as of 19:45, 8 February 2014

Back to Upgrading Hardware

BE ABSOLUTELY SURE THAT YOU ARE RUNNING THESE COMMANDS AGAINST THE CORRECT DRIVE.
WE CANNOT ACCEPT RESPONSIBILITY FOR ANY DATA LOSS.
These guidelines are very brief and require someone with Linux experience to execute correctly.

Step 1

Determine the kernel hardware label for the new disk.

After connecting the new disk to the server and rebooting, login to the server using a console and type; 

sudo fdisk -l

This command will list all the disks attached and the kernel label used.

Step 2

Create a linux partition on the new disk.

Assuming that you identified the new disk as /dev/sdb, from step 1 above, then type the following to create a single linux ext4 partition on the new disk; 

sudo -i

parted /dev/sdb mklabel gpt

parted /dev/sdb mkpart primary ext4

parted /dev/sdb print

exit

Step 3

Make a linux filesystem on the new disk.

Step 2 above should have created a single primary linux partition on the disk.

Type the following to create an ext4 file system on the disk; 

sudo mkfs.ext4 /dev/sdb1

Step 4

Make a mount point on the linux file system for the new disk.

Since the new disk will be used for an added asset store, we create the mount folder where DSpace was installed. 

sudo mkdir /home/dspace/assetstore/two

Step 5

Mount the new disk to the mount point on the linux file system.

Definitions

References

Retrieved from "http://wiki.lib.sun.ac.za/index.php?title=SUNScholar/Upgrading/Hardware/Add_a_New_Disk&oldid=25225"